topic Wireless clients cannot access WLC Management interface.. in Wireless

Wireless clients cannot access WLC Management interface..

Anvar Mohammed — Mon, 05 Jul 2021 10:27:27 GMT

wireless clients can ping wlc management ip but can not access controller web interface,

management via wireless clients are allowed at wlc confgiuration,

i can access it through dynamic interface,, but not through management ip

attached sh-run config

thanks,

anvar

This is a bad thing? What is

Stephen Rodriguez — Wed, 24 Jun 2015 13:51:06 GMT

This is a bad thing?

What is the issue, do you want your clients to be able to manage the WLC?

Steve

i had implemented more than

Anvar Mohammed — Wed, 24 Jun 2015 14:00:29 GMT

i had implemented more than 20 controllers, were i didn't find this case before, so i just need to know why it should not work.

basically i don't need wireless clients to access WLC management interface,, but why it is not working ??? while i can ping it,, but no SSH or GUI

thanks,

anvar

Re: i had implemented more than

rajesh.netratrk — Fri, 13 Oct 2017 14:42:09 GMT

Just came across same scenario!

Access to WLC management interface from its own wireless clients is blocked by default. But it can be enabled manually,

Management-->Mgmt via Wireless (on left side)---> click the check box on page to enable (self explanatory)

Re: Wireless clients cannot access WLC Management interface..

Daniel Ordóñez Flores — Fri, 13 Oct 2017 18:10:58 GMT

Hi there.
I can't see you file, one question your WLC is in HA SSO mode?

Re: Wireless clients cannot access WLC Management interface..

singhmanaspratap — Sat, 14 Oct 2017 08:35:29 GMT

Hi,

As per config attached Mgmt via wireless is enabled , secure webmode is also enabled. Please try accessing WLC via https:// , http would not work.

By the way Cisco would not recommend enabling Mgmt via wireless access unless there is a requirement from the Customer.

Thanks and regards,

Manas Pratap Singh

Re: Wireless clients cannot access WLC Management interface..

Vengatesa Prasath — Sun, 15 Oct 2017 14:14:54 GMT

Have you tested with client on same subnet of wireless management interface? if so what is the status.

Is it possible to collect uplink capture from WLC? Working and non working scenario (working: When tried with dynamic inerface && Non working: When tried with management interface)