topic Re: Change the RAM, will sort the in Wireless

WLC 2112 is not accessable

GR-IT-Network — Mon, 05 Jul 2021 06:58:33 GMT

Hello Experts,

I have a problem with my Cisco WLC 2112.

Problems:

1. I can not reach this WLC via GUI or CLI.

2. Can not access via Console.

3. Status LED is Dark Orange or Red.

Can anybody help.

Regards

Re: WLC 2112 is not accessable

Sandeep Choudhary — Wed, 15 Jan 2014 14:13:40 GMT

Hi,

Status LED is Amber(ORANGE/RED)— Means Problem encountered during boot.

http://www.cisco.com/en/US/docs/wireless/controller/2100/quick/guide/ctrl206q.html#wp39363

Did u tried with these settings:

9600 baud

8 data bits

No flow control

1 stop bit

No parity

If the console is not responsive, then its a hardware failure and you should contact the TAC or You should RMA'd it.

Be aware: WLC 2100 Series are EOL/EOS.

http://www.cisco.com/en/US/prod/collateral/wireless/ps6302/ps8322/ps7206/ps7221/end_of_life_notice_c51-691053.html

Regards

Dont forget to rate helpful posts

Re: WLC 2112 is not accessable

Scott Fella — Wed, 15 Jan 2014 14:13:51 GMT

Your WLC is dead. The status light is in alarm, so nothing you can do to fix that as that device is EOS also.

Sent from Cisco Technical Support iPhone App

Re: WLC 2112 is not accessable

GR-IT-Network — Wed, 15 Jan 2014 14:16:58 GMT

Thanks for your quick Help.

Yes I have tried with these setting but still not able to access.

Re: WLC 2112 is not accessable

Sandeep Choudhary — Wed, 15 Jan 2014 14:17:44 GMT

Ok,

Power down the WLC and then power it back up and then see if the WLC comes back up and then try replacing the power supply and see.. if still face the issue, then u have to buy new one 25500 or 5500 series.

Regards

Dont forget to rate helpful posts

Re: WLC 2112 is not accessable

GR-IT-Network — Wed, 15 Jan 2014 14:18:47 GMT

Thanks....I will try to buy new one .

Thanks again for all your quick help.

Change the RAM, will sort the

nrothwellir — Tue, 03 Nov 2015 13:19:47 GMT

Change the RAM, will sort the Boot issue 🙂 2 years late lol

Re: Change the RAM, will sort the

michaelweston — Wed, 20 Nov 2019 16:16:02 GMT

Nearly 5 years on, following your advice has fixed my ancient 2106. It rolled over a few days ago after a neighbourhood power surge and I was all set to purchase a replacement from eBay when I came across this thread. A quick rummage in my old spares box produced a replacement RAM module and a few minutes later, WLC springs back to life. Thanks very much for the tip!!!

Re: Change the RAM, will sort the

CollinWav11 — Thu, 21 Nov 2019 15:03:31 GMT

Our WLC went down yesterday, and I just ran across this thread. Sure enough, this fix worked for me as well. Replaced the RAM with a spare module from an old scrap Dell Dimension 4600. Worked great. Thanks!

Re: WLC 2112 is not accessable

alvaroke1 — Fri, 30 Apr 2021 03:23:16 GMT

Well I must post here aswell it might help any1...In my case the RAM was only moved... so I removed the case, pluged in correctly the RAM... and voila! 😃