topic WLC 4404 brick, what can i do? in Wireless

WLC 4404 brick, what can i do?

denis_kondrashov — Sun, 04 Jul 2021 07:49:44 GMT

Hello!

Yesterday's power off. After turning on the controller wlc 4404 does not boot.

On the console, we get the following:

Net:

PHY DEVICE : Found Intel LXT971A PHY at 0x01

FEC ETHERNET

IDE: Bus 0: OK

Device 0: not available

Device 1: not available

Booting Primary Image...

Press <ESC> now for additional boot options...

Error (no IRQ) dev 0 blk 0: status 0x51

Error reg: 10

** Can't read from device 0 **

** Unable to use ide 0:4 for fatload **

Error (no IRQ) dev 0 blk 0: status 0x51

Error reg: 10

** Can't read from device 0 **

** Unable to use ide 0:4 for fatload **

bzImage Image Integrity Check Failed(Bad Magic Number). Hanging

Apparently damaged flash. I have new CF256Mb.

There are ways to recover?

WLC 4404 brick, what can i do?

Leo Laohoo — Thu, 12 Sep 2013 22:45:54 GMT

Do you have a valid Service Contract to RMA the appliance?

WLC 4404 brick, what can i do?

denis_kondrashov — Fri, 13 Sep 2013 08:31:17 GMT

No End User havn't Service contract.

Re: WLC 4404 brick, what can i do?

Scott Fella — Fri, 13 Sep 2013 11:34:29 GMT

Then there isn't much you can do, because you would probably have to RMA it. I think they are end of support also so you wouldn't be able to purchase a support contract.

Sent from Cisco Technical Support iPhone App