topic cannot access GUI on WLC 7.2 in Wireless

cannot access GUI on WLC 7.2

miket — Sun, 04 Jul 2021 06:22:54 GMT

I have a SRE 710 that has a WLC 710 on it. Everything was working including GUI...A interface got added and in the name there is a space ie:" WLC GUI" within a few minutes I reset a CUE on a SRE and within a minute the GUI stopped on the WLC. I tried to remove the interface but I cannot and I suspect it is the space causing issues.

Has anyone seen this and any ways to recover?

Re: cannot access GUI on WLC 7.2

Kayle Miller — Mon, 28 Jan 2013 14:51:41 GMT

Mike,

If you have an interface name that is messed up.. Can you telnet or SSH to the controller?? If so then I would copy the config off using TFTP or FTP; edit the config and then re-upload the config to the controller that will alleviate the interface name issue. As for the GUI make sure that the

config securewebmode enable

command has been run at the CLI or console.

Hope this helps