topic Guest Anchor WLC Version 7.2 in Wireless

Guest Anchor WLC Version 7.2

ThoDoepke — Sun, 04 Jul 2021 06:03:34 GMT

Hello,

I am trying to configure a guest tunnel between a local and an anchor WLC. I used the information posted in another discussion https://supportforums.cisco.com/message/3312270#3312270 and the config guide for version 7.2.

On the local WLC I configured the anchor WLC as anchor for the WLAN SSID and the status is up.

On the anchor WLC I can only select the other WLC but not the anchor itself as written in the guide.

The tunnel obviously doesn't work (I don't get an IP from DHCP-Server).

Did the config changuration change in version 7.2 or did I miss maybe something?

Re: Guest Anchor WLC Version 7.2

nikhilcherian — Fri, 16 Nov 2012 11:04:51 GMT

On the anchor WLC, can you see local in the drop down menu

Guest Anchor WLC Version 7.2

ThoDoepke — Fri, 16 Nov 2012 11:16:25 GMT

OK I forgot to mention that I’m using two 2504 controller in a test environment and they don’t support this feature.

Sorry my fault.

Re: Guest Anchor WLC Version 7.2

Naveen Kumar — Wed, 11 Sep 2013 04:05:57 GMT

Just to share with you:

There is a good discussion available on Guest Access with Mobility Anchor Chalk Talk:

https://supportforums.cisco.com/docs/DOC-13459

Re: Guest Anchor WLC Version 7.2

Abhishek Abhishek — Wed, 11 Sep 2013 22:46:16 GMT

Client mobility among controllers works only if auto-anchor mobility (also called guest tunneling) or symmetric mobility tunneling is enabled. Asymmetric tunneling is not supported when mobility controllers are behind the NAT device. For more information do refer to the link-

http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_mobility.html

Re: Guest Anchor WLC Version 7.2

ThoDoepke — Thu, 12 Sep 2013 07:31:15 GMT

I already solved my problem by installing a newer version on the 2504 wlc. I'm currently running 7.4 without any problems.

Version 7.2 simply doesn't support the 2504 as an anchor for a mobility group.