topic Refer the link : https:/ in Wireless

Cannot Access GUI on AIR-CAP2602I-A-K9 Access Point

agray000111111 — Mon, 05 Jul 2021 11:43:14 GMT

No matter what I try I cannot get into the configuration mode which is where I believe I need to be to enable the web GUI. When I put in its DCHP assigned IP address I cannot access the GUI. Obviouly I can Putty into it on the Console port. Thought?

HS-AP252-B102A#conf ?
% Unrecognized command
HS-AP252-B102A#configure ?
% Unrecognized command
HS-AP252-B102A#config ?
% Unrecognized command

Alex

The is a controller based

Philip D'Ath — Fri, 04 Mar 2016 01:21:26 GMT

The is a controller based access point. It has no GUI on the access point. You use the controller to configure it.

Refer the link : https:/

mohanak — Fri, 04 Mar 2016 01:57:07 GMT

Refer the link : https://supportforums.cisco.com/discussion/11905426/failing-access-web-interface-2602i-ap

Okay, makes sense now. LOL

agray000111111 — Fri, 04 Mar 2016 03:55:21 GMT

Okay, makes sense now. LOL

Okay so then I have 4 of these APs that we have attached to our network and the ports on the switch are configured the same way the ports that have other working APs. Those 4 are not connecting to the WLC. So that was the reason I was trying to get into the GUI of a working AP to see if the configs were different.

Check the log on the access

Philip D'Ath — Fri, 04 Mar 2016 04:04:47 GMT

Check the log on the access point log. It should be a big hint.