topic Using my router as an access point in Wireless

Using my router as an access point

anikaburrowes11 — Mon, 05 Jul 2021 10:15:09 GMT

Hi guys,

I have a Cisco Linksys E1200 router. I'm trying to use this router as an access point. I've followed p.36 of this manual: http://downloads.linksys.com/downloads/userguide/E_Series_UG_E900Rev_3425-01486_Web.pdf which, in point 4, says to find "bridge mode" in Cisco connect. I can't find bridge mode in the settings.

Can somebody please give me a screenshot, or direct me to exactly where bridge mode is?

Thanks

Select the Bridge Mode using

Moin Ilyas — Tue, 19 May 2015 14:01:19 GMT

Select the Bridge Mode using the following steps.

Please refer :http://jgiam

varunag — Tue, 19 May 2015 18:39:27 GMT

Please refer :

http://jgiam.com/2012/07/06/setting-up-a-repeater-bridge-with-dd-wrt-and-d-link-dir-600

follow the discussionshttps:/

Saurav Lodh — Wed, 20 May 2015 11:56:11 GMT

follow the discussions

https://community.linksys.com/t5/Wireless-Routers/Configuring-e1200-as-wireless-bridge/td-p/532530

In the Internet Connection

sobhardw — Thu, 21 May 2015 19:33:39 GMT

In the Internet Connection Type drop-down list, click the type of
Internet connection provided by your ISP and select the option as Bridge mode.

Below is the screenshot and let me know If you need any other assistance.

The Firmware of your Linksys

nicolas.brouard — Sat, 04 Jun 2016 17:17:31 GMT

The Firmware of your Linksys E1200 router is too old. You can get a newer at http://www.linksys.com/us/support-article?articleNum=148523 and you can read (current firmware for version 1 is 1.0.04) but bridge support has been added on 1.0.02. Just dowload and go to Firmware update and you will the bridge facility.

Firmware 1.0.02 (build 5)
- Added bridge mode support