topic APs ship with lightweight in Wireless

No access with Cisco Aironet 702i AIR-SAP702I-A-K9

anthony.belliot — Mon, 05 Jul 2021 09:50:50 GMT

Hi,

I have bought AIR-SAP702I-A-K9 and I have started it.

I can find this IP, I can ping it, but not access (http/80 or telnet or ssh)...

Is the access point is KO ?

In getting started guide, it says the AP search controller but I have not controller, i want to use the AP an autonomous...

I tried to reset the AP from 2 times, but same problem ...

Any idea.

Thanks

Leo Laohoo — Fri, 03 Apr 2015 10:07:41 GMT

You really need a console cable to start putting config on an autonomous AP.

It's not dead.

William Kuczmera — Fri, 03 Apr 2015 14:19:44 GMT

APs ship with lightweight code. You need to convert your ap to autonomous.

The preso below may be helpful for you.

https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa

anthony.belliot — Fri, 03 Apr 2015 14:28:08 GMT

Thanks,

I have download the autonomous firmware and upload it with tftp with mode button.

now it's ok.

I go to bed less stupid... 😉

Scott Fella — Fri, 03 Apr 2015 17:02:36 GMT

+5 Will

Glad to see you posting on the forums Will, along with your very first 5 points and correct answer!

-Scott