topic Re: Lightweight access point - cold reset in Wireless

Lightweight access point - cold reset

battanc — Sun, 04 Jul 2021 02:29:59 GMT

How could I force a cold RESET to a Lightwieght AP?

My 4400 controller are 5.2 and starting with 5.1 there is no Telnet nor SSH access to the AP.

I search a way outside the controller - I suppose via SNMP, but witch MIB ?

Thank's

Claudio

Nicolas Darchis — Thu, 02 Dec 2010 12:19:05 GMT

You can still go on the WLC to the AP advanced properties and enable telnet and ssh. Did you try that ?

I suppose that a reset from the WLC is not something you are looking for ?

Nicolas

===

Don't forget to rate answers that you find useful

battanc — Thu, 02 Dec 2010 12:56:48 GMT

Starting with 5.2.x, You can not enable Telnet nor SSH.

I can perform Reset from the WLC, but I am looking for an "indipendent" reset

Claudio

Nicolas Darchis — Thu, 02 Dec 2010 13:10:58 GMT

You can do it on 6.x ... I didn't realize that this disappeared only in 5.2 ? strange.

try the following :

debug ap enable

debug ap command "reload"

This is the way to send commands to the APs from the WLC command line. I don't know if reload will be accepted though.

Nicolas

===

Don't forget to rate answers that you find useful