topic number of users per Access point in Wireless

number of users per Access point

johnramz — Sun, 04 Jul 2021 06:54:32 GMT

Hi community:

Two questions about planning wireless setup:

1- Is there a resource/whitepaper from CISCO that recpmmends the number of users per Access point ? I figure the model should also be taken into account.

2- Any recommended tool to plan the location of the Access point in a building ?

Thanks

Juan

number of users per Access point

Scott Fella — Fri, 12 Apr 2013 14:52:09 GMT

The rule of thumb is 25 devices per ap and it depends on the application being used on the wireless. Video you might be only able to get 4-6 users and if its just email and web traffic you might be able to have 40-50. Wireless is half duplex, so since its shared, the more devices, the less available throughput per device.

I use AirMagnet to perform a site survey so I know the optimum location that AP's need to be placed.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

number of users per Access point

Scott Fella — Fri, 12 Apr 2013 14:52:54 GMT

Search the forum for max number of users per ap and you will find many threads...

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

number of users per Access point

johnramz — Fri, 12 Apr 2013 15:14:16 GMT

Scott,

I see your ration 20-25 per AP referenced in other answered questions, however I could not find anyone citing/quoting a CISCO documentation that supports this.

Do you know of any source that documents this rule of the thumb?

Thanks

Juan

number of users per Access point

Scott Fella — Fri, 12 Apr 2013 15:17:33 GMT

Here is an old doc for voice but its still the recommendation.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a008009483e.shtml

Q. How many wireless IP telephony handsets are recommended per AP?

A. IP telephony network sizing is essential to ensure that adequate bandwidth and resources are available to carry mission-critical voice traffic. In addition to the usual IP telephony design guidelines for sizing components, such as PSTN gateway ports, transcoders, WAN bandwidth, and so forth, also consider these 802.11b issues when sizing your wireless IP telephony network:
Number of 802.11b devices per AP: Cisco recommends that you have no more than 15 to 25.
Number of 802.11b phones per AP

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

number of users per Access point

johnramz — Fri, 12 Apr 2013 15:29:34 GMT

Scott,

I wish there would be a more up-to-date source and even considering "g" and "n" but you are very responsive and insightful . I will mark one of your replies as "Correct Answer" because it is.

Juan

number of users per Access point

Scott Fella — Fri, 12 Apr 2013 17:33:20 GMT

Its still the same... and its more of users like us out there that have experienced what works and what doesn't. Cisco will state that you can have up to 200 clients per radio, which is the limit, but it all comes down to what the customer is going to be doing with the wireless.... I have had installs with 802.11N access points and had a requirement of 4GB of data to be transferred via FTP within 30 minutes and we could only get 4 devices to transfer at the same time to accomplish the requirement. So you have to look at the amount of throughput you want clients to have also. You don't give enough, they complain, so again... how much do your users complain:)

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

number of users per Access point

johnramz — Fri, 12 Apr 2013 17:38:37 GMT

Scott,

Thanks again for your responsiveness and insight. Very tru what you are saying. It depends on the type of use and the users

Would you mind taking a look a this other question I posted under the same "getting started ..." forum.?

It is labeled:

Design question: Access points and controller Logical/Physical placement

Thanks

Juan

number of users per Access point

Scott Fella — Fri, 12 Apr 2013 17:40:04 GMT

Sure...

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"