topic username n password to have a CLI from access point by telnet in Wireless

username n password to have a CLI from access point by telnet

taufan prakasa — Sun, 04 Jul 2021 06:28:00 GMT

Hi there,

can you help me to tell which username and password that can be used to telnet a joined access point? is it the default username n password or username from local management user? i haven't put any username n password to that access point.

thanks

regards

Taufan

username n password to have a CLI from access point by telnet

Stephen Rodriguez — Fri, 01 Feb 2013 19:39:39 GMT

There is no 'default' per se. You would configure it globally for the AP, or on a per AP basis. And you need to go in and enable telnet/ssh to the AP.

And on that note, why are you looking to go to the AP directly if it's managed by the WLC?

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

username n password to have a CLI from access point by telnet

taufan prakasa — Fri, 01 Feb 2013 19:54:27 GMT

Hi Steve,

it's just crossed in my mind that if the AP have lost connection to WLC, i don't need to put a console on it.

can i set that username on WLC?

thanks for your response by the way

regards

username n password to have a CLI from access point by telnet

Stephen Rodriguez — Fri, 01 Feb 2013 19:59:24 GMT

yes all configurabel from the WLC. Wireless > Access Points > Global Configuration

but you'd have to get into it quick and do a debug capwap client no-reload so that it doesn't reboot when it can't find/join the WLC.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

username n password to have a CLI from access point by telnet

taufan prakasa — Fri, 01 Feb 2013 20:09:04 GMT

ok...i get it

really appreciate for your kind help Steve

thanks

Regards

Taufan

Re: username n password to have a CLI from access point by telne

clarkvyborg — Mon, 04 Feb 2013 02:01:08 GMT

Can you setup TACACS access? I currently have the APs set to SSH but it is a common username / password.

Sent from Cisco Technical Support iPad App