Error in adding Data Points in WCS when using Intel 5100 AGN card

nomadicwifi — Sun, 04 Jul 2021 01:47:32 GMT

I am using Wireless Control System (WCS) 6 and when I try to add data points in a custom calibration model I created, I get an error message "No data points collected when starting from location (X,Y)" only when using Intel 5100 AGN as the client. I know that in order to add Data Points, I need to have a wireless card that supports Cisco CCX, this Intel card supports CCX 4.

I have done added data points using my older computer that uses an older Intel card and it works fine. I used another computer that has a Dell Wireless 1510 Wireless-N card and it works too. The driver on the Intel 5100 AGN is 13.1.1.1(13/01/2010)

Is there a solution to this or is the Intel 5100 AGN just not supported?

Re: Error in adding Data Points in WCS when using Intel 5100 AGN

Lucien Avramov — Tue, 11 May 2010 08:54:52 GMT

There is probably something with the card and the CCX support.

Have you tried to do a wireless packet capture to make sure it does indeed support CCX?

We dont test other vendor nic cards for the driver / feature reason, it makes it about impossible to track all the NIC cards, hence we recommend the card we have since we know that the driver is correct.

----

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com

topic Re: Error in adding Data Points in WCS when using Intel 5100 AGN in Wireless

Error in adding Data Points in WCS when using Intel 5100 AGN card

Re: Error in adding Data Points in WCS when using Intel 5100 AGN