topic Re: Ap 1832i as standalone in Wireless

Ap 1832i as standalone

tomaszaniol — Mon, 05 Jul 2021 15:42:59 GMT

Hello, I have few AIR-ap1832i-e-k9 configured as CAPWAP lightweight (the AP Image Type and AP Configuration fields are not present in the output)

Software:

AP Running Image : 8.2.141.0
Primary Boot Image : 8.2.141.0

Is there any way to configure AP as standalone AP (I don't wan't to have this ap as a client of controller or controller itself)?

Re: Ap 1832i as standalone

Rasika Nayanajith — Thu, 07 Jun 2018 10:48:35 GMT

You can use it in Mobility Express mode where AP itself got WLC functionality enabled.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-2/b_Mobility_Express_Deployment_guide/b_Mobility_Express_Deployment_guide_chapter_0100.html

HTH

Rasika

*** Pls rate all useful responses ***

Re: Ap 1832i as standalone

tomaszaniol — Thu, 07 Jun 2018 11:01:49 GMT

Thank you for reply

I have few boxes which will be working in the same network but don't want to WLC. I need only separete AP functionality, not controller.

Re: Ap 1832i as standalone

abhishek68 — Fri, 08 Jun 2018 02:24:21 GMT

The Mobility Express Access Points cannot be configured in Standalone Mode. However you can configure the Access Point as Mobility Express Controller where the AP can function as an AP as well as the Controller. Also you need to keep in mind that the Mobility Express Controller cannot co-exist with other WLC in the network.

You can refer the below link for more clarity.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-3/b_Cisco_Mobility_Express_Deployment_Guide/b_Cisco_Mobility_Express_Deployment_Guide_chapter_010.html