topic Like Sandeep mentioned, your in Wireless

Error in configuration of APs

Muhammad Noman — Mon, 05 Jul 2021 13:21:17 GMT

Dear All,

I am trying to configure controller based AP but not AP is not able to appearing on controller. Upon power on of AP it appears on controller for a second or two and then disappears with following message errors.

Regards,

Muhammad Noman

Paste the output of these

Sandeep Choudhary — Fri, 13 Jan 2017 08:41:26 GMT

Paste the output of these commands:

sh sysinfo from WLC

sh version from AP

*** I suspect that Regulatory mismatch is there...

Regards

Dont forget to rate helpful posts

Dear Sandeep,

Muhammad Noman — Fri, 13 Jan 2017 10:22:23 GMT

Dear Sandeep,

Please find the attached snapshot

Like Sandeep mentioned, your

Scott Fella — Fri, 13 Jan 2017 10:38:13 GMT

Like Sandeep mentioned, your country code is the issue. If you look at the configured country code on the AP sticker or on the output you attached the -A is for Americas. Your controller has another country code defined BH. You need to add Americas to your controller if you want that AP to join.

https://www.google.com/amp/s/mrncciew.com/2013/04/07/configuring-country-codes-on-wlc/amp/?client=safari

-Scott

*** Please rate helpful posts ***

Dear Scott,

Muhammad Noman — Mon, 16 Jan 2017 05:47:00 GMT

Dear Scott,

When i change the country on WLC from -BH to -A then already configured AP which are working with WLC will they also effect or not?

Regards,

Muhammad Noman

if these old AP have diff.

Sandeep Choudhary — Mon, 16 Jan 2017 07:05:54 GMT

if these old AP have diff. regulatory domain then -A- then of-course it will affect.

If you are not using Mesh APs then you can have "two country- Bahrin and USA" configured on WLC so that both type of AP will work but only with common channels and power.

Reagrds

Dont forget to rate helpful posts