Trouble configuring Aironet 1142 - %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an IP !!

cfbeavers — Mon, 05 Jul 2021 10:28:05 GMT

I will start off by saying, my network skills are very remediate... but I'm having an issue. I am wanting to configure 2 of my existing AP's for a new host name and IP. I am wanting to do this via Serial (which I have) and using PuTTY. When I initially connected, I went into enable, and tried typing in config t and it says invalid input. I went in and reset to factory. Now, I can go into enable but this message keeps popping up and it's very frustrating. Message is: %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an IP !!

Now, these are my commands available:

Exec commands:
cd               Change current directory
clear            Reset functions
clock            Manage the system clock
crypto           Encryption related commands.
debug            Debugging functions (see also 'undebug')
delete           Delete a file
dir              List files on a filesystem
disable          Turn off privileged commands
enable           Turn on privileged commands
exit             Exit from the EXEC
fsck             Fsck a filesystem
help             Description of the interactive help system
led              LED functions
lock             Lock the terminal
login            Log in as a particular user
logout           Exit from the EXEC
lwapp            lwapp exec commands
mkdir            Create new directory
monitor          Monitoring different system events
more             Display the contents of a file
name-connection Name an existing network connection
no               Disable debugging functions
ping             Send echo messages
pwd              Display current working directory
release          Release a resource
reload           Halt and perform a cold restart
rename           Rename a file
renew            Renew a resource
rmdir            Remove existing directory
send             Send a message to other tty lines
set              Set system parameter (not config)
show             Show running system information
systat           Display information about terminal lines
terminal         Set terminal line parameters
test             Test subsystems, memory, and interfaces
traceroute       Trace route to destination
undebug          Disable debugging functions (see also 'debug')
upgrade          Upgrade software
verify           Verify a file
where            List active connections

Not sure what the next step is, and how to get rid of that message. I do not want to connect to my WLC just yet, I just want to program via Serial since this will be on a different subnet IP than what is here, locally.

Please refer to the below

sobhardw — Thu, 25 Jun 2015 22:18:09 GMT

Please refer to the below link :

http://mrncciew.com/2013/03/17/ap-registration/

Hi,This is a CAPWAP AP and it

Sandeep Choudhary — Fri, 26 Jun 2015 07:08:54 GMT

Hi,

This is a CAPWAP AP and it can only be managed when you have Wirless LAN controller.

If you want to change hostmname and IP via serial interface then do these:

1. Run this command "debug capwap console cli"

2. Then start using config t and run your normal command to change both.

Regards

Don't forget to rate helpful posts

topic Please refer to the below in Wireless

Trouble configuring Aironet 1142 - %CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an IP !!

Please refer to the below

Hi,This is a CAPWAP AP and it

Refer the link : AP not