topic Standalone AP Audit in Wireless

Standalone AP Audit

ALIAOF_ — Mon, 05 Jul 2021 09:31:48 GMT

Are there no commands/method(s) available to see the SSID's as well as the type of encryption each one is using? So far the only way I have been able to find is:

- show dot11 bssid (But this only shows the SSID) and then have to do show runn to see what each SSID is using such as WPA or WEP, TKIP etc

Need to check this on a whole buncha AP's but can't really script it if there is no single command available.

That is the way you can check

Saurav Lodh — Wed, 18 Feb 2015 01:32:37 GMT

That is the way you can check the authentication types, similar way you apply per ssid

Thanks I do know that, I

ALIAOF_ — Wed, 18 Feb 2015 15:28:07 GMT

Thanks I do know that, I wanted to see if there is another better way to accomplish this though.

The easiest way is either

Carlos Leiton — Wed, 18 Feb 2015 18:09:11 GMT

The easiest way is either through the GUI, you will have a summary of each SSID with its encryption.

If you don't want to issue a show run, then the most easy way will be to run a command like this:

For the encryption (per radio):

ap#show run interface dot11Radio 0 | inc encryption

ap#show run interface dot11Radio 1 | inc encryption

For the SSID:

ap#show run | sec ssid

Beside of this, there is no other command that I am aware of

HTH

Thank you that is much better

ALIAOF_ — Wed, 18 Feb 2015 22:27:12 GMT

Thank you that is much better. Shame that there isn't a specific command for that. I guess with the controller based AP's now it isn't needed any more.