topic Refer the link for power in Wireless

Will the 2702 AP require the full 15W?

Mathieu Sturm — Mon, 05 Jul 2021 08:05:22 GMT

Will the 2702 AP require the full 15W? Should a switch labeled as POE+ give every AP enough power? The HP procurve 2530-24G POE+ deliveres 195W but we're not sure if it can support all 24 ports.

Yes 2702 AP requires 15W.

Sandeep Choudhary — Wed, 25 Jun 2014 11:57:04 GMT

Yes 2702 AP requires 15W.

Normally its depend on the length of the cable connecting from swicth to AP.

"When deployed using a Power over Ethernet (PoE) specification, the power drawn from the power sourcing equipment will be higher by some amount dependent on the length of the interconnecting cable."

Regards

Dont forget to rate helpful posts

Adding to Sandeep,The access

Moin Ilyas — Tue, 23 Sep 2014 22:19:17 GMT

Adding to Sandeep,

The access point is 802.3af (15.4 W) compliant and can be powered by any 802.3af-compliant device.

The recommended external power supply for the access point is the Cisco AIR-PWR-B power supply. The access point can also be powered by the following optional external power sources:

– Access point power injector (AIR-PWRINJ5)

– Any 802.3af compliant power injector

This summarize 2700 PoE

Rasika Nayanajith — Tue, 23 Sep 2014 23:48:32 GMT

This summarize 2700 PoE requirement (fig 106 in the given link)

http://www.cisco.com/c/en/us/td/docs/wireless/technology/apdeploy/7-6/Cisco_Aironet_3700AP.html

HTH

Rasika

**** Pls rate all useful responses ****

Refer the link for power

mohanak — Wed, 24 Sep 2014 08:54:48 GMT

Refer the link for power specifiacation:

http://www.cisco.com/c/en/us/td/docs/wireless/technology/apdeploy/7-6/Cisco_Aironet_3700AP.html#pgfId-124333