topic That's true, but would also in Wireless

Show AP LAN interface speed

patoberli — Mon, 05 Jul 2021 07:48:59 GMT

Hello All

I currently discovered that two of my APs are running with 100 Mbit/s instead of 1 Gbit/s. This clearly can give a few issues with 802.11n speeds. The affected APs are 3502. They are managed through two WiSMs (7.0.250.0). Those are managed through PI 2.1.

Is there some possibility to see the interface speed of all APs in one place, or do I really have to select every single AP and check the interface speed?

Thanks

Patrick

You can view the speeds of

Leo Laohoo — Mon, 12 May 2014 22:47:14 GMT

You can view the speeds of your APs from the switch.

That's true, but would also

patoberli — Tue, 13 May 2014 07:31:45 GMT

That's true, but would also mean to login to nearly 100 switches and check the interface. They are not in PI.

I think your out of luck if

Scott Fella — Tue, 13 May 2014 14:16:35 GMT

I think your out of luck if you are trying to get this data from the WLC. You would have to look at each switch.

To bad :(The data is in WLC

patoberli — Tue, 13 May 2014 14:19:11 GMT

To bad 😞

The data is in WLC (Monitor -> Accesspoint -> click one -> Interfaces -> click Gigabitethernet0), but would have hoped to see it with less clicks.

I think that would not be just useful for us, what do you think?

GUI is the worse for

Scott Fella — Tue, 13 May 2014 14:27:46 GMT

GUI is the worse for gathering large amount of data.... try this command from the CLI of the WLC:

show ap stats ethernet summary

Please rate helpful post and Cisco Support Community will donate to Kiva

Scotty

Great! That was exactly what

patoberli — Tue, 13 May 2014 14:38:03 GMT

Great! That was exactly what I was searching for 🙂

Then you can use the show ap

Scott Fella — Tue, 13 May 2014 14:39:15 GMT

Then you can use the show ap cdp neighbor all to find out what switch and port it is connected to.

Please rate helpful post and Cisco Support Community will donate to Kiva

Scotty

show ap stats ethernet

Abhishek Abhishek — Wed, 28 May 2014 23:05:01 GMT

show ap stats ethernet summary

Use the command-show ap stats

Abhishek Abhishek — Thu, 29 May 2014 17:59:54 GMT

Use the command-

show ap stats ethernet summary

Re: Show AP LAN interface speed

Ben Crissman — Tue, 08 Oct 2024 03:17:48 GMT

I was searching for 9800's and this old thread popped up. so ill update for 9800's too.

AirOS old controllers = show ap stats ethernet summary
9800's = show ap ethernet statistics | inc AP Name|Mbps