topic BW limit per SSID / AP in Wireless

BW limit per SSID / AP

mplaksin0 — Sun, 04 Jul 2021 06:51:39 GMT

Hi;

It is possible to apply a limit of bandwidth per SSID using the WLC?. In case of not being possible, is it possible to apply for Access-Point?

Thanks

BW limit per SSID / AP

Saravanan Lakshmanan — Sun, 07 Apr 2013 20:41:12 GMT

http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a0080bd3900.shtml

with wism, 4400, 5500, WiSM2,.. supports to limit bandwdith per user/ssid/interface on downlink, the later code supports bidirection rate limiting using software.

wlc like 2500, sre, vwlc doesn't support bandwidth contract.

Currently only 5760 & 3850 can do very granular per user/wlan/radio/ap level line ratelimiting using hardware.

BW limit per SSID / AP

Leo Laohoo — Sun, 07 Apr 2013 22:18:51 GMT

Firmware 7.0.X can limit bandwidth on a per user level.

Firmware 7.4.X can limit bandwidth on a per user or per SSID level.

BW limit per SSID / AP

mplaksin0 — Sun, 07 Apr 2013 23:56:18 GMT

Thanks for the answer. We use 5500 WLC. I am looking the release notes of 7.4.1 firmware ( http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn74.html ) and i dont see per wlan rate-limit as a feature.

Where i can find some documentation?

Thanks

Re: BW limit per SSID / AP

Scott Fella — Mon, 08 Apr 2013 00:43:17 GMT

Take a look at this link

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/system_management/config_system_management_chapter_01110.html

Sent from Cisco Technical Support iPhone App

BW limit per SSID / AP

mplaksin0 — Mon, 08 Apr 2013 14:36:52 GMT

Thanks you very much

BW limit per SSID / AP

Abhishek Abhishek — Wed, 10 Apr 2013 13:10:54 GMT

Hello,

As per your query i can propose the solution-

Yes it is possible to apply a limit of bandwidth per SSID using the WLC.

Firmware 7.0.X can limit bandwidth on a per user level.

Firmware 7.4.X can limit bandwidth on a per user or per SSID level.

BW limit per SSID / AP

Saravanan Lakshmanan — Wed, 10 Apr 2013 18:24:05 GMT

Well, 7.0 can still do per user and per ssid bandwidth control, the downside is qos profile configured for wireless que is locked to those 4 profiles. Ex: Besteffort profile que configured with X value configured on global config can be applied to one wlan, if different wlan require different throttling then that can't be done. And per user works only if the user is linked to the configured profile, so there is no mehanism to fair share the available bandwidth among the clients on that wlan.