topic Re: Cisco AP LED status blinking red in Wireless

Cisco AP LED status blinking red

LauraMumbua1576 — Mon, 05 Jul 2021 19:00:54 GMT

I have a cisco aironet 1832i preloaded with Mobility Express Software version 8.5.140.

This access point was previously working as the primary controller up until recently when the users complained of no internet connection. Upon checking the boot process via the console I can see the following loop " Waiting for uplink IPv4 configuration". I have already logged a case with cisco but any idea on what the issue could be would be of assistance.

Re: Cisco AP LED status blinking red

Leo Laohoo — Mon, 04 May 2020 07:55:49 GMT

Waiting for uplink IPv4 configuration

Means the AP/WLC has booted up without any IP address.

Re: Cisco AP LED status blinking red

Rafael E — Mon, 04 May 2020 11:12:14 GMT

did another AP take over as ME WLC?

how does this AP should get IP Address?

what is the switch port configuration that you have for this AP?

do you see any request on your DHCP server coming from this AP?

Re: Cisco AP LED status blinking red

LauraMumbua1576 — Tue, 05 May 2020 07:34:51 GMT

did another AP take over as ME WLC?

Yes another AP took over as WLC once this one became "faulty"

how does this AP should get IP Address?

It gets the IP via DHCP. There is a DHCP server already installed.

what is the switch port configuration that you have for this AP?

This is a client's access point and from my knowledge, they just connected directly to the switch port.

do you see any request on your DHCP server coming from this AP?

What I know is that the other APs have recieved an IP address apart from this one.

I would need to get confirmation is the same for this AP.

Re: Cisco AP LED status blinking red

patoberli — Mon, 11 May 2020 15:43:22 GMT

Yes, currently the reason it doesn't work is because it didn't receive an IP address, for whatever reason. Full DHCP lease table, faulty network cable, buggy dhcp server, ...

Re: Cisco AP LED status blinking red

LauraMumbua1576 — Tue, 12 May 2020 13:23:01 GMT

The DHCP table doesn't seem to be full as other devices are getting IP's from the DHCP server, the network cable is working as I connected another Cisco Aironet 1832i AP.

Re: Cisco AP LED status blinking red

Scott Fella — Tue, 12 May 2020 16:13:35 GMT

Did you console into the ap and look at the output? The output will show you what is wrong.