topic Re: LED Lights on AP in Wireless

LED Lights on AP

wellsjo — Sat, 03 Jul 2021 20:12:06 GMT

What does it mean when the radio light is a constant green?

Re: LED Lights on AP

Rob Huffman — Tue, 07 Nov 2006 21:53:02 GMT

Hi Joy,

Hopefully these are the guides you are looking for, if I missed the one you need let me know.

Cisco Aironet 1000 Series Lightweight Access Point Hardware Installation Guide

Checking the Access Point LEDs

http://www.cisco.com/en/US/products/ps6306/products_installation_guide_chapter09186a008069a25d.html#wp1030793

Cisco Aironet 1100 Series Access Point Hardware Installation Guide,

Checking the Lightweight Access Point LEDs

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_installation_guide_chapter09186a00806a623a.html#wp1030793

Checking the Autonomous Access Point LEDs

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_installation_guide_chapter09186a00806a61ea.html#wp1030793

Cisco Aironet 1240AG Series Access Point Hardware Installation Guide

Troubleshooting 1240AG Series Autonomous Access Points / Checking the Top Panel LEDs

http://www.cisco.com/en/US/products/ps6521/products_installation_guide_chapter09186a00806a7973.html#wp1015872

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

Troubleshooting Autonomous Access Points / Checking the Top Panel LEDs

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_installation_guide_chapter09186a00806a69f1.html#wp1030793

Hope this helps!

Rob

Please remember to rate helpful posts.....

Re: LED Lights on AP

johnruffing — Wed, 08 Nov 2006 14:42:26 GMT

As noted in other threads on the forum, if you are using the lightweight version of the AP, there is an error condition where the AP LED on the LAP-1131AG access point LED will display the light green color (typically indicating normal operation) when it is unable to obtain an IP address via DHCP.

This is a known bug that Cisco is in the process of remediating.

- John

Re: LED Lights on AP

wellsjo — Wed, 08 Nov 2006 19:46:05 GMT

Thanks for the response. I was getting frustrated and should have been more specific, sorry. The AP is an Aironet 1200 series and it has a static IP. It has been in a territory "war" with another Cisco AP of which I have no control over. The other party set the other IP to broadcast over "a" only and that seemed to help a lot. Now I am trying to fine tune signal drops and disconnections. I noticed that at times the bottom (radio) light stays solid green and couldn't find out what that meant in the LED TS chart.

J. Wells