https://community.cisco.com/t5/wireless/ap-repeater-root-setup/m-p/312774#M137961 <P>Anyone know why I am getting the following message on my repeater AP?</P><P></P><P>%DOT11-4-CANT_ASSOC: Interface Dot11Radio0, cannot associate: No Response</P><P></P><P>My repeater aP dot110 interface shows a status of reset when I set the station-role repeater. I was able to get the repeater AP to associate to the Root AP a few times but then it would lose connectivity. Is this issue related to RF? My test AP's are very close to each other.</P><P></P><P>Here is what I have. </P><P></P><P>Repeater AP</P><P></P><P>interface Dot11Radio0</P><P> no ip address</P><P> no ip route-cache</P><P> !</P><P> encryption mode ciphers tkip</P><P> !</P><P> ssid xxxxx</P><P> authentication open</P><P> authentication key-management wpa</P><P> infrastructure-ssid</P><P> wpa-psk ascii 7 xxxxxxx</P><P> !</P><P> short-slot-time</P><P> parent 1 0000.aaaa.bbbb</P><P> speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0</P><P> station-role repeater</P><P> bridge-group 1</P><P> bridge-group 1 subscriber-loop-control</P><P> bridge-group 1 block-unknown-source</P><P> no bridge-group 1 source-learning</P><P> no bridge-group 1 unicast-flooding</P><P> bridge-group 1 spanning-disabled</P><P></P><P></P><P>Root AP:</P><P></P><P>interface Dot11Radio0</P><P> mac-address 0000.aaaa.bbbb</P><P> no ip address</P><P> no ip route-cache</P><P> !</P><P> encryption mode ciphers tkip</P><P> !</P><P> ssid xxxxx</P><P> authentication open</P><P> authentication key-management wpa</P><P> infrastructure-ssid</P><P> wpa-psk ascii 7 xxxxx</P><P> !</P><P> short-slot-time</P><P> speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0</P><P> channel 2412</P><P> station-role root</P><P> bridge-group 1</P><P> bridge-group 1 subscriber-loop-control</P><P> bridge-group 1 block-unknown-source</P><P> no bridge-group 1 source-learning</P><P> no bridge-group 1 unicast-flooding</P><P> bridge-group 1 spanning-disabled</P><P>!</P><P></P><P>Thanks</P> Sun, 04 Jul 2021 17:33:26 GMT slewe 2021-07-04T17:33:26Z https://community.cisco.com/t5/wireless/ap-repeater-root-setup/m-p/312774#M137961 <P>Anyone know why I am getting the following message on my repeater AP?</P><P></P><P>%DOT11-4-CANT_ASSOC: Interface Dot11Radio0, cannot associate: No Response</P><P></P><P>My repeater aP dot110 interface shows a status of reset when I set the station-role repeater. I was able to get the repeater AP to associate to the Root AP a few times but then it would lose connectivity. Is this issue related to RF? My test AP's are very close to each other.</P><P></P><P>Here is what I have. </P><P></P><P>Repeater AP</P><P></P><P>interface Dot11Radio0</P><P> no ip address</P><P> no ip route-cache</P><P> !</P><P> encryption mode ciphers tkip</P><P> !</P><P> ssid xxxxx</P><P> authentication open</P><P> authentication key-management wpa</P><P> infrastructure-ssid</P><P> wpa-psk ascii 7 xxxxxxx</P><P> !</P><P> short-slot-time</P><P> parent 1 0000.aaaa.bbbb</P><P> speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0</P><P> station-role repeater</P><P> bridge-group 1</P><P> bridge-group 1 subscriber-loop-control</P><P> bridge-group 1 block-unknown-source</P><P> no bridge-group 1 source-learning</P><P> no bridge-group 1 unicast-flooding</P><P> bridge-group 1 spanning-disabled</P><P></P><P></P><P>Root AP:</P><P></P><P>interface Dot11Radio0</P><P> mac-address 0000.aaaa.bbbb</P><P> no ip address</P><P> no ip route-cache</P><P> !</P><P> encryption mode ciphers tkip</P><P> !</P><P> ssid xxxxx</P><P> authentication open</P><P> authentication key-management wpa</P><P> infrastructure-ssid</P><P> wpa-psk ascii 7 xxxxx</P><P> !</P><P> short-slot-time</P><P> speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0</P><P> channel 2412</P><P> station-role root</P><P> bridge-group 1</P><P> bridge-group 1 subscriber-loop-control</P><P> bridge-group 1 block-unknown-source</P><P> no bridge-group 1 source-learning</P><P> no bridge-group 1 unicast-flooding</P><P> bridge-group 1 spanning-disabled</P><P>!</P><P></P><P>Thanks</P> Sun, 04 Jul 2021 17:33:26 GMT https://community.cisco.com/t5/wireless/ap-repeater-root-setup/m-p/312774#M137961 slewe 2021-07-04T17:33:26Z