topic 350 AP and throughput in Wireless

350 AP and throughput

Netset — Sun, 04 Jul 2021 16:08:18 GMT

Hi!

I've been having a problem lately with following setup: 350 AP, newest firmware, reset to defaults. 350 PC-Card, newest Software Package & Firmware.

Signal strength between 90% and 100%. Signal quality between 60% and 70%.

Problem: When I transfer data, the rate drops to 2Mbps consistently. I'm assuming when I use the bandwidth it first tries 11Mbps, then switches to 5.5Mbps and finally to 2Mbps.

I did a site survey:

1Mbps: 0 packets lost to target, 0 lost to source

2Mbps: 2 packets lost to target, 0 lost to source

5.5Mbps: 999 packets (all) lost to source, 0 to target

11Mbps: 999 packets lost to source, 0 to target

So does anybody know what's going on? I'd appreciate all help.

Regards. Igor

Re: 350 AP and throughput

derwin — Wed, 12 Nov 2003 01:23:36 GMT

Igor,

Sounds like you have a noisy RF environment there.

On the AP do you see a lot of CRC errors and hold offs??

Re: 350 AP and throughput

Netset — Wed, 19 Nov 2003 21:59:52 GMT

Actually, I do. When transferring data, the CRC errors increase rapidly.

Regarding a site survey test, what would be "normal" values for a site. I've set the channels according to what the manual says is the best frequency after doing the survey, but that doesn't say anything about absolute values.

Any clues?

Greetings. Igor