topic If you do a search for guest in Wireless

Wireless problems with Aironet Air-AP1041N

sefimizra — Mon, 05 Jul 2021 09:11:58 GMT

Hello,

I have Aironet Air-AP1041N and I wrote it the next CLI commands to define its wireless:

interface Dot11Radio0
no ip address
no ip route-cache
no shutdown
ssid mPrest_Test
speed basic-1.0 basic-2.0 basic-5.5 basic-11.0
station-role root access-point
payload-encapsulation dot1h
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
end

But I still can't see the wireless SSID when I try to find it with other devices.

Do I miss something?? any ideas?

Thanks

Sefi

You need to add guest-mode if

Scott Fella — Tue, 30 Dec 2014 15:09:57 GMT

You need to add guest-mode if you want to broadcast the SSID

http://www.cisco.com/c/en/us/support/docs/interfaces-modules/security-modules-routers-switches/116586-config-ap-00.html

-Scott

Hi Scott,In this link I didn

sefimizra — Tue, 30 Dec 2014 17:01:32 GMT

Hi Scott,

In this link I didn't find any guest-mode.

Did you mean that I need to configure vlan to the interface?

Thanks

Hi Sefi, Use the following

singhmanaspratap — Tue, 30 Dec 2014 17:45:24 GMT

Hi Sefi,

Use the following commands:

config t
dot11 ssis mPrest_Test
guest mode

If this does not help please paste the output of show run from the Access Point.

Thanks and regards,

Manas Pratap SIngh.

If you do a search for guest

Scott Fella — Tue, 30 Dec 2014 18:38:43 GMT

If you do a search for guest-mode, you will find it under method 2. This will broadcast the SSID so it's not hidden.

-Scott

Thanks, Now its work but how

sefimizra — Wed, 31 Dec 2014 15:22:51 GMT

Thanks,

Now its work but how can I make the radio to work with the gigaethernet interface that everyone that connect to the SSID will connect the gigaethernet interface?

Hi , Clients connecting to

singhmanaspratap — Thu, 01 Jan 2015 00:40:34 GMT

Hi ,

Clients connecting to the ssid will connect to the radio interface. the gig interface is up once it is connected to the switch port via ethernet cable.

I would suggest you to ping the show run config so that we can analyse the configuration once. If clients are connecting fine and wireless connectivity is working as per the expectation you may close this thread and mark the ans as correct.

Thanks and regards,

Manas Pratap Singh