topic how to enter into interface configuration mode on aironet 1130AG in Wireless

how to enter into interface configuration mode on aironet 1130AG

moonviewingjp — Sun, 04 Jul 2021 04:48:45 GMT

How can I enter into "interface configuration" on Aironet 1130AG, AIR-LAP1042N?

When I put following commands in enable

conf t
interface Dot11Radio1

but, it fails and I cannot enter into "interface configuration".

How can I do this ?

The reason why I enter into

conf t
interface Dot11Radio1

because I want to disable cdp via CLI ( serial console).

best regards

how to enter into interface configuration mode on aironet 1130AG

nikhilcherian — Sun, 18 Mar 2012 12:31:25 GMT

You can enable the command "debug capwap console cli" and enter into the config mode

If you want to disable cdp, you can do from WLC using the command

config ap cdp disable

Thanks

NikhiL

how to enter into interface configuration mode on aironet 1130AG

moonviewingjp — Sun, 18 Mar 2012 16:19:28 GMT

Thank you for your information.

Is it possible to disable cdp by using " no cdp enable " after entering into the config mode on 1130AG via CLI ?

like ,

interface Dot11Radio0

no cdp enable

best regards

how to enter into interface configuration mode on aironet 1130AG

nikhilcherian — Sun, 18 Mar 2012 17:03:37 GMT

int gig 0

no cdp enable

this command also will work out

you should give in gig interface and not in radio interface

Regards

Nikhil

how to enter into interface configuration mode on aironet 1130AG

George Stefanick — Sun, 18 Mar 2012 17:53:52 GMT

Just a quick fyi -- You know when you have a CAPWAP ap when you console in and your config t doesnt work . Config t will only work on autonomous access points.

Re: how to enter into interface configuration mode on aironet 11

Justin Kurynny — Sun, 18 Mar 2012 18:17:35 GMT

George,

I ran into an exception the other day – lightweight 3500s (and presumably 3600s) are allowing config t without the debug precursor. The lab version I’m doing this on is 7.0.220.0. Do you have same/different results? I’m not sure if this is tied to the AP model or the lw code they’re running. I’ll need to do some more testing.

Justin

Re: how to enter into interface configuration mode on aironet 11

George Stefanick — Sun, 18 Mar 2012 18:22:22 GMT

Justin,

You dont say!? Looks like I may need to take a peek as well.

Re: how to enter into interface configuration mode on aironet 11

George Stefanick — Sun, 18 Mar 2012 18:22:46 GMT

+5 ... Keep up the good work on the forums!

Re: how to enter into interface configuration mode on aironet 11

Justin Kurynny — Sun, 18 Mar 2012 18:32:57 GMT

George,

Thx!

Justin

how to enter into interface configuration mode on aironet 1130AG

moonviewingjp — Wed, 21 Mar 2012 16:29:28 GMT

I found that my office 's one aironet's interface,

nterface Dot11Radio0

no cdp enable

How can it be configured?

Best regards