topic You need "AP Group VLANs in Wireless

Diferent DHCP servers with the same ssid

sonel.claudiu — Mon, 05 Jul 2021 10:31:48 GMT

Hi,

I have 8 APs AIR-AP3702I and a controller WLC 2504. I want to have the same SSID, but I want that 4 of them to use 10.0.0.0/24 ip pool, and other 4 to use 10.0.2.0/24 pool.

Thanks,

Claudiu

You will want to look into

Stephen Rodriguez — Wed, 08 Jul 2015 14:47:53 GMT

You will want to look into the AP Groups feature.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/71477-ap-group-vlans-wlc.html

HTH,

Steve

Please refer to the below

sobhardw — Wed, 08 Jul 2015 22:33:55 GMT

Please refer to the below link :

https://supportforums.cisco.com/document/74486/ap-group-vlan-logic-wireless-lan-controllers-wlc-configuration-example

You need "AP Group VLANs

gohussai — Fri, 10 Jul 2015 17:10:17 GMT

You need "AP Group VLANs feature" in your 2504 Controller.

Check the following link for proper configuration step by step.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/71477-ap-group-vlans-wlc.html

Here is the step by step GUI

Prakash Parvathala — Wed, 29 Jul 2015 16:46:18 GMT

Here is the step by step GUI configuration guide of the AP group VLans with images.

https://www.cisco.com/public/technotes/smbsa/en/us/wireless/config_AP_Grp_VLANs_WLANs.pdf

for reference please look the below steps

Steps to configure via GUI

Go to the controller GUI and choose WLANs > AP Groups VLANs.
Check AP Group VLANs Feature Enable and then click Apply in order to enable the AP Group VLANs feature.
Enter the AP Group Name and Description and then click Create New AP-Group in order to create a new AP group.
For the new AP group , click on Detail. Select the appropriate SSID from the WLAN SSID pull-down menu and the interface with which you wish to map this AP group. [ The final task is to assign the LAPs to the appropriate AP groups ]
Go to the controller GUI and choose Wireless > Access Points > All APs.
Click on the Detail link for an LAP in order to assign an LAP to an AP group.
Set AP Group Name to the name of the appropriate AP group from the AP Group name