topic AP software in Wireless

AP software

skelley5000 — Mon, 05 Jul 2021 07:35:25 GMT

I upgraded my controller and pre-downloaded the image to all of the AP's for a later reboot. When I try to reboot the controller I get the following message.

AP software being upgraded, please try again later

All AP's show the image has been pre-downloaded

I need some suggestions on how to reboot the Controller, with out actually powering the Controller off and back on

If you can go to CLI, enter

Leo Laohoo — Mon, 31 Mar 2014 21:58:55 GMT

You can check, using CLI, if all of your APs have complete pre-downloading using the command "sh ap image all". On the first page, make sure the "Total Number of APs" value is correct and the next five lines below this is "0". If not, you should see (in the next subsequent pages) which APs haven't finished the predownloading.

In the meantime, enter this command "reset system FORCED" to force the controller to reboot.