topic Associate SSID with only one user in Wireless

Associate SSID with only one user

alkabeer80 — Sun, 04 Jul 2021 04:56:35 GMT

Hi, I have created new ssid and i want to associate only one IP address with this SSID, so that only this user will be allowed to connect to AP.

I have controller 5500 series.

thanksssss

Associate SSID with only one user

Surendra BG — Wed, 04 Apr 2012 03:42:30 GMT

Configure MAC filter allowing only 1 MAC and this will not allow any other mac to connect.. this is the easient way to do it..

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008058ed26.shtml#macbasedacls

Please let me know if this helps and dont forget to rate the usefull posts!!

Regards

Surendra

Associate SSID with only one user

Surendra BG — Wed, 04 Apr 2012 03:43:45 GMT

Discard my Previous post.. thats for the Autonomous AP.. here is the same on WLC environment..

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008084f13b.shtml

Please let me know if this helps and dont forget to rate the usefull posts!!

Regards

SUrendra

Associate SSID with only one user

alkabeer80 — Wed, 04 Apr 2012 05:48:38 GMT

hi thanks for reply, i have checked the MAC filtering it shows "MAC Filtering is not supported with HREAP Local authentication"

Can i do it with IP address ?

Associate SSID with only one user

Leo Laohoo — Wed, 04 Apr 2012 06:05:04 GMT

Can i do it with IP address ?

No because anyone can get the IP address. Static IP address won't help either because someone can configure static address on their client and could cause issues.

Associate SSID with only one user

alkabeer80 — Wed, 04 Apr 2012 06:35:19 GMT

what about this message

"MAC Filtering is not supported with HREAP Local authentication"

Associate SSID with only one user

Amjad Abdullah — Wed, 04 Apr 2012 09:54:35 GMT

Sir,

it seems you are using HREAP access point. right?

If your HREAP is using local authentication it will not support MAC filtering by design.

You need either to move the AP to centralized authentication or change it from HREAP to Local mode.

With HERAP Local authentication mac filtering does not work and this is mentioned in foot notes in WLC GUI -> WLANs -> choose WLAN -> security -> Layer 2. (I am using verison 7.0.116.0. not sure if difference on other versoins).

HTH

Amjad