broadcast multiple SSIDs

sdewildt — Sun, 04 Jul 2021 17:38:51 GMT

I'm trying to set up an access point with multiple vlans and SSIDs. I wish to have a public and a private network as well as a vlan for voice. How can I do this so clients can connect to the VLAN they want?

Re: broadcast multiple SSIDs

mbadcock — Wed, 06 Apr 2005 07:40:53 GMT

Hi,

If you are setting up multiple VLAN's on the 1200 series access point, you need to assign a new SSID to each VLAN..

Eg,

SSID is Vlan1-A and is assigned to Vlan1

SSID is Vlan2-A and is assigned to Vlan2

After setting up the SSID's you need to ensure that you configure the Native Vlan, this is a drop down box on the same page. Set this to your normal management Vlan.

You also need to set the ports that are to be used by the access points on the switch to trunk ports, as follows;

interface fastethernet 0/1 {or select port required}

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport mode trunk

You also need to do this on the port used for the Cisco ACS server.

To enable users to access different Vlan's simply set their client card to access the SSID that is assigned to the Vlan that they want to use.

Hope this helps.

Many Thanks

topic Re: broadcast multiple SSIDs in Wireless

broadcast multiple SSIDs

Re: broadcast multiple SSIDs