topic Re: Can't pass traffic when in centrally switched wlan using vWL in Wireless

Can't pass traffic when in centrally switched wlan using vWLC

Dave Anthony David — Sun, 04 Jul 2021 05:38:46 GMT

Im using 1131AG AP.

Locally switched WLAN don't have problem.

Authentication used: open/wpa-psk/wpa2-psk

Pinging the IP Address of the vWLC dynamic interface (WLAN-SSID Mapping) is ok, but with the gateway failed.

Any ideas how to solve this?

Re: Can't pass traffic when in centrally switched wlan using vWL

Scott Fella — Tue, 11 Sep 2012 00:54:13 GMT

Do you have the networks in VM configured correctly. This is tough, because now we have to see how your VM environment is setup.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

Re: Can't pass traffic when in centrally switched wlan using vWL

Dave Anthony David — Tue, 11 Sep 2012 02:49:17 GMT

Hi Scott, let me check on this.. For sure I've configured the vWLC Data Port in promiscuous mode.

What I'm not sure of is if they are sitting on the same Virtual Switch..

I'll let you know then.. Thanks.

Re: Can't pass traffic when in centrally switched wlan using vWL

Dave Anthony David — Tue, 11 Sep 2012 12:51:00 GMT

Thanks Scott, you are correct. My VM Network was incorrectly configured.

But what I don't understand is that, the working config of my vWLC Data Port was mapped to vSphere Standard Switch whereas not working was at vSphere Distrubuted Switch and they have the same configuration (promiscuos mode - accept). I didn't touch the vWLC Service Port which is right now connected to a vSphere Distrubuted Switch with different uplink and is disconnected.

Re: Can't pass traffic when in centrally switched wlan using vWL

Scott Fella — Tue, 11 Sep 2012 13:19:26 GMT

I'm not an ESXi expert, but I created a new network just for the service port an then I created networks for each of my centrally switched vlans. That is how I have mine configured.

Sent from Cisco Technical Support iPhone App

Re: Can't pass traffic when in centrally switched wlan using vWL

Scott Fella — Tue, 11 Sep 2012 13:23:28 GMT

I'm not an ESXi expert, but I created a new network just for the service port an then I created networks for each of my centrally switched vlans. That is how I have mine configured.

Sent from Cisco Technical Support iPhone App

Re: Can't pass traffic when in centrally switched wlan using vWL

Dave Anthony David — Tue, 11 Sep 2012 13:31:41 GMT

I'm not an ESXi expert too.. Anyway, it looks like you are using vSphere Standard Switch.

Re: Can't pass traffic when in centrally switched wlan using vWL

Scott Fella — Tue, 11 Sep 2012 13:44:11 GMT

Yes that is correct. I can test it our later if you need me to.

Sent from Cisco Technical Support iPhone App

Can't pass traffic when in centrally switched wlan using vWLC

Dave Anthony David — Tue, 11 Sep 2012 13:55:17 GMT

Greatly appreciated. Well if its ok with you to test.. I would love to hear the results..

Re: Can't pass traffic when in centrally switched wlan using vWL

Dave Anthony David — Mon, 17 Sep 2012 09:55:25 GMT

Hi Scott, when you say "I created networks for each of my centrally switched vlans", what do you mean by this?

Are you not using the trunk port 4095? Please see my snapshot.

Re: Can't pass traffic when in centrally switched wlan using vWL

Scott Fella — Mon, 17 Sep 2012 11:40:37 GMT

Did you create them on the vWLC. The SSID that these users are associating to, what interface are they mapped to?

Sent from Cisco Technical Support iPhone App

Re: Can't pass traffic when in centrally switched wlan using vWL

Dave Anthony David — Mon, 17 Sep 2012 12:56:19 GMT

Yes. Its mapped in VLAN120 interface. Here's the screenshot.

Re: Can't pass traffic when in centrally switched wlan using vWL

Dave Anthony David — Fri, 21 Sep 2012 14:30:39 GMT

Internet Firewall at my remote site is messing up with my CAPWAP tunnel.

I really don't know which port has been blocked. Afterall FlexAPs at remote site might need to unblock more ports other than UDP 5246/5247. Weird!!!