topic Re: Multiple ports on Virtual Wireless Controller in Wireless

Multiple ports on Virtual Wireless Controller

cisco — Mon, 05 Jul 2021 15:00:16 GMT

Hi,

I have installed a Virtual Wireless Controller (version 8.3) on ESXi and I am working with the setup. I have a question abount ports and VLANS. Now the controller has only one port, the management-interface is connected to this port. But now I want to configure multiple SSIDs and connect these SSIDs to different VLANS.

To do this I have connected interfaces for the diffrent VLANS to the Controller-VM on ESXi and I expected to see these interfaces as ports on the vWLC, but I still see only one port on the vWLC. How can I see the interfaces connected from ESXs as ports on the vWLC and then map new interfaces on the vWLC to these ports?

Re: Multiple ports on Virtual Wireless Controller

Flavio Miranda — Wed, 20 Dec 2017 11:24:06 GMT

Hi,

You need to work with trunk. Enable LAG on the WLC side, CINTROLLER tab and configure trunk on the vswitch on the ESXi. Then, you can segment you SSIDs per VLAN.

-If I helped you somehow, please, rate it as useful.-

Re: Multiple ports on Virtual Wireless Controller

cisco — Wed, 20 Dec 2017 12:54:19 GMT

Hi and thanks for your answer!

I am not sure if I understand this correct. On ESXi I have a vSwitch with multipe VM-networks (VLANS), as shown. The management-network is assigned to the vWLC, but I also want to assign other networks to the vWLC and map different interfaces on vWLC to these networks. Is this not possible?

Re: Multiple ports on Virtual Wireless Controller

Flavio Miranda — Wed, 20 Dec 2017 13:04:16 GMT

It is. Thats why I say you need trunk between WLC and vSwitch.

-If I helped you somehow, please, rate it as useful.-

Re: Multiple ports on Virtual Wireless Controller

cisco — Wed, 20 Dec 2017 13:16:19 GMT

Can you explain how to create this trunk between vWLC and ESXi?

Re: Multiple ports on Virtual Wireless Controller

Flavio Miranda — Wed, 20 Dec 2017 22:44:33 GMT

On the WLC side you just need to put it in LAG mode. Go to CONTROLLER tab and enable it.

On the ESXi side you can find some guide on the internet.

-If I helped you somehow, please, rate it as useful.-

Re: Multiple ports on Virtual Wireless Controller

Mikolaj Moryto — Wed, 20 Dec 2017 23:19:51 GMT

Hi,

You may not need LAG on the vWLC side. At least I do not have it in my setup and it works.

All you need to do for setting up the trunk to vWLC is create new port group in ESXi vSwitch and set VLAN ID for that port group to be 4095. Setting it to be 4095 simply makes it a trunk and vSwitch will forward VLAN tags to your vWLC.

Thank you,

Mikolaj

Re: Multiple ports on Virtual Wireless Controller

Arnoldo — Tue, 28 Jan 2020 17:07:42 GMT

Funciona, gracias.