topic Hi Leo Laohoo, Thanks for in Wireless

Changing IP Address Controllers

igorromanluz — Mon, 05 Jul 2021 08:16:31 GMT

Hi,

Own two 5508 controllers operating in HA SSO. Became necessary to accomplish the change of addressing these. Both addresses will remain the same subnet, however the question arose whether to undo the HA configurations or is there a way to alter these addresses without removing these settings.

Thank you.

Igor Luz

You'll need to break HA,

Leo Laohoo — Wed, 23 Jul 2014 22:18:42 GMT

You'll need to break HA, change the IP address of the Management and the Redundant Management (as necessary).

If The new IP is going to

Ambuj M — Thu, 24 Jul 2014 02:47:49 GMT

The new IP is going to remain in same subnet

Gateway is going to remain same

Redundant peer IP is going to remain same.

then on the active controller you can go ahead and change the IP, and it will be overwritten on the standby, you might not have to break redundancy.

your AP's however need to re-register, option 43 and DNS entry have to be changed.

Let me know if it worked for you

***Rate all useful posts***

Hi Leo Laohoo, Thanks for

igorromanluz — Thu, 24 Jul 2014 11:34:33 GMT

Hi Leo Laohoo,

Thanks for your reply. I'll be performing the adjustments.

hugs.

Igor

Hi Ammahend,Thanks for your

igorromanluz — Thu, 24 Jul 2014 11:39:13 GMT

Hi Ammahend,

Thanks for your reply.

The Subnet will change, for example, will 10.10.xx/24 network to network 10.20.xx/24.
I believe if you change the subnet, you must disable the HA controllers. Correct or not you need to disable.

Thanks for all the support.

Igor

Leo is correct... Disable AP

Scott Fella — Thu, 24 Jul 2014 11:43:30 GMT

Leo is correct... Disable AP SSO and reconfigure the management IP address for both. You can change the AP's high availability for the primary WLC with the new IP address also before your break AP SSO and change the IP address. This way the AP has the info.

Scott