topic Error in setting country code -- Wireless Lan Controller in Wireless

Error in setting country code -- Wireless Lan Controller

ciscoroyzhang — Sun, 04 Jul 2021 04:34:42 GMT

Hi all

try to setup a LAP for Singapore office, has encounter above errror message.

Following Country codes: AU, KR,NZ,PH,SG has been enalbed in Country Page. the LAP AIR-CAP3502I-S-K9 has been associated with KR intially. We try to change it to SQ, but the error persists. this AP has been setup as HREAP, any suggestion?

Thanks

Roy

Re: Error in setting country code -- Wireless Lan Controller

Stephen Rodriguez — Tue, 14 Feb 2012 12:37:55 GMT

Do you still have the AP local to you do you could capture the console output while setting the country?

Steve

Sent from Cisco Technical Support iPhone App

Error in setting country code -- Wireless Lan Controller

ciscoroyzhang — Tue, 14 Feb 2012 23:35:58 GMT

Yes Stephen, I still have it with me ( in Sydney). I would like to test it before send them to Singapore. should I wait for it to be pluged into Singapore office then configure the contry code?

Error in setting country code -- Wireless Lan Controller

ciscoroyzhang — Thu, 16 Feb 2012 00:10:32 GMT

find the answer: disable the access point then it allow country code to be changed.

Re: Error in setting country code -- Wireless Lan Controller

Nickolus Looper — Tue, 30 Jan 2018 01:50:27 GMT

Awesome, that totally worked - thanks for the tip!!

Re: Error in setting country code -- Wireless Lan Controller

jkilleda — Fri, 02 Mar 2018 09:58:25 GMT

Hello Roy,

Error in setting country code -- Wireless Lan Controller
Generally you configure one country code per controller, however WLC code 4.1 onwards allows you to configure up to 20 country codes per controller. This enables you to manage APs in various countries from a single controller. For a given AP all radios should be in same regulatory domain. There is an exception for MESH APs where you have to configure single country code on WLC for them to register.