topic installing additional WAP with 520 wireless controller in Wireless

installing additional WAP with 520 wireless controller

rjames976 — Sun, 04 Jul 2021 04:25:11 GMT

I currently have a 520 wireless lan controller and 3 AIR-LAP521G-A-K9 access points. I've been asked to install an additional AIR-AP1231G-A-K9. will this work in the existing environment? Should I have to do anything to this extra access point before plugging it into the network?

Re: installing additional WAP with 520 wireless controller

Stephen Rodriguez — Fri, 20 Jan 2012 16:33:02 GMT

the 1231 you are showing is an IOS AP, so you would need to configure it manually. It can run a lightweight image, but it won't join the WLC 520, as the 520 only supports the 500 series AP.

As the 1231 won't join the WLC seamless roaming probably will not work, if you are doing WPA/WPA2 as it would not get the PMK to fast roam.

If you really need to add more wireless you should get another 500 AP and join it to your WLC instead of adding in that 1231.

Steve

Sent from Cisco Technical Support iPad App

installing additional WAP with 520 wireless controller

rjames976 — Fri, 20 Jan 2012 16:45:49 GMT

great info. thanks. When I get an additional AIR-LAP521G-A-K9, do they require configuring beforehand, or will the controller detect and configure it?

Re: installing additional WAP with 520 wireless controller

Stephen Rodriguez — Fri, 20 Jan 2012 16:52:21 GMT

only thing it should need to do is get an address in the AP VLAN.

Steve

Sent from Cisco Technical Support iPad App