topic Controller doesn't update in Wireless

Controller doesn't update

polleyjb01 — Sun, 04 Jul 2021 03:51:44 GMT

I just updated my 4404 controller with 7.0.116.0.

After I rebooted and check the version number on the monitor page, it tells me its still version

7.0.98.0. The weird thing is, is that the Emergency Image Version is what changed to version 7.0.116.0.

Re: Controller doesn't update

Stephen Rodriguez — Tue, 04 Oct 2011 00:23:49 GMT

What files did you load?

Sent from Cisco Technical Support iPad App

Controller doesn't update

polleyjb01 — Tue, 04 Oct 2011 11:29:58 GMT

I downloaded a file from Cisco called AIR-WLC4400-K9-7-0-116-0-ER.aes

Controller doesn't update

Angus Bishop — Tue, 04 Oct 2011 12:40:06 GMT

HI Brandon,

Please issue the Show boot command from the CLI and see the image versions

I feel you might have loaded from the backup image

Please rate the post if its helpful ...

Regards

Angus

Re: Controller doesn't update

Stephen Rodriguez — Tue, 04 Oct 2011 12:57:06 GMT

Ok. The ER at the end of the file means that it is the Emergency Recovery image and sometimes a boot loader update. You need to also grab the other file AIR-wlc4400-k9-7-0-116-0.aes. This file is the upgrade to the WLC OS.

Sent from Cisco Technical Support iPad App

Controller doesn't update

polleyjb01 — Tue, 04 Oct 2011 13:01:04 GMT

I just tried to telnet through a few of the IP's listed under interfaces but I couldn't get in

Controller doesn't update

Angus Bishop — Tue, 04 Oct 2011 13:16:22 GMT

HI Brandon ,

The code is downloadable from the link

http://www.cisco.com/cisco/software/release.html?mdfid=279911269&flowid=7587&softwareid=280926587&release=7.0.116.0&relind=AVAILABLE&rellifecycle=ED&reltype=latest

use the cco id to login.

Regards

Angus

Controller doesn't update

Stephen Rodriguez — Tue, 04 Oct 2011 13:21:13 GMT

Telnet is not enabled on the WLC, and should only respond on the management interface by default.