topic Re: Wireless controller issues in Wireless

Wireless controller issues

a.macready — Sat, 03 Jul 2021 21:18:41 GMT

I have just deployed a 4402 wireless controller and updated autonomous 1231 aironets to lightweight mode. All works ok.

I create an interface on a vlan and added IP addresses etc.

Whenever i attempt to associate a WLAN with the interface the only interface available is Management

Another problem is if I create a interface and dont enable Dynamic AP management I loose access to the controller and have to remove the interface via the service port.

Any ideas would be welcome

Re: Wireless controller issues

ericgarnel — Mon, 09 Jul 2007 17:11:24 GMT

On the WLC, is the newly created interface enabled?

You should enable dynamic ap management on the management interface or other interface, not a dynamically created interface for client traffic.

Is the port from the switch to WLC in trunk mode?

Re: Wireless controller issues

jwadleigh — Fri, 24 Aug 2007 17:44:31 GMT

Confirm the following:

1.) Management and AP-Manager interface are on a single VLAN.

2.) Dynamic Interface is on a different VLAN and enabled.

3.) Both VLAN's exist on the connected switch.

4.) The connected switch port is configured as a dot1q trunk including both VLAN's listed above.