topic Re: Radio interface Oper Status Down in Wireless

Radio interface Oper Status Down

blackswans — Mon, 05 Jul 2021 07:06:33 GMT

Hi,

Some of our AP's oper status are getting down. Their admin status are enabled but why they are getting down? Even I reboot the AP they are still down.

Our software version is : 7.5.102.0

Controller 5508

Thanks.

Re: Radio interface Oper Status Down

George Stefanick — Thu, 06 Feb 2014 13:25:07 GMT

What radio is it and do all the access points on the controller show the same ?

Sent from Cisco Technical Support iPad App

Re: Radio interface Oper Status Down

George Stefanick — Thu, 06 Feb 2014 13:25:20 GMT

What type of ap ?

Sent from Cisco Technical Support iPad App

Re: Radio interface Oper Status Down

Sandeep Choudhary — Thu, 06 Feb 2014 13:38:44 GMT

Hi,

Check these:

1. Choose Wireless > 802.11a/n or 802.11b/g/n > Network

Select the 802.11a (or 802.11b/g) Network Status check box to enable the 802.11a or 802.11b/g band.

2. Wireless > Access Points > All APs then click on specific AP and make sure admin status is enable.

if you are using Power INjector then

Go to Wireless > Access Points > All AP’s > Click on specific AP then go to Advanced and check the Power Injector state.

If still fails to come up then paste the output of these commands:

1. WLC: sh sysinfo; and

2. AP: sh version

Regards

Radio interface Oper Status Down

Abhishek Abhishek — Mon, 10 Feb 2014 17:45:20 GMT

What kind of wireless NIC are you using?

How was it set up?

Ordinarily, eth interfaces are typically wired, not wireless.

Aside from those anomolies,

Research your NIC

Consider alternate drivers

Reboot the AP now and maybe regularly

Consider replacing the AP

Radio interface Oper Status Down

Ali Aqrabawi — Mon, 10 Feb 2014 18:02:22 GMT

many reasons causes the radio down , can you provide logs ? both radios go down ? or one of them ?

Radio interface Oper Status Down

Leo Laohoo — Mon, 10 Feb 2014 22:04:06 GMT

Some of our AP's oper status are getting down. Their admin status are enabled but why they are getting down? Even I reboot the AP they are still down.

Hmmmmm ... All the radios or just one radio?

I'd be checking the Regulatory Domain of the APs and make sure they match with the Country settings of the WLC.

Re:Radio interface Oper Status Down

Ali Aqrabawi — Tue, 11 Feb 2014 19:27:19 GMT

yeah why not

Sent from Cisco Technical Support Android App

Re:Radio interface Oper Status Down

blackswans — Wed, 12 Feb 2014 11:03:24 GMT

Only two AP and only the 5Ghz is down. Reg domain is correct and same with the others.

Radio interface Oper Status Down

Leo Laohoo — Wed, 12 Feb 2014 11:04:47 GMT

Can you please post the output to the following commands:

1. WLC: sh sysinfo;

2. AP: sh version

Re:Radio interface Oper Status Down

Sandeep Choudhary — Wed, 12 Feb 2014 11:28:54 GMT

provide more info.... as me and leo asked in our respective posts.

sh version -- From AP

sh sysinfo - From WLC

may be u have multicountry configured on WLC ?

Regards

Re: Radio interface Oper Status Down

Scott Fella — Wed, 12 Feb 2014 12:58:04 GMT

I just had an issue with that with v7.4.110.0 and some 2602's. 1142's were fine. Seemed like when I bounced the WLC or mad a change to RRM some of the AP's would disassociate and come back to the WLC. What I noticed is a few would have their radios down and I have to manually disable and enable to get then working again. I upgraded to v7.4.121.0 and seemed to be a bit more stable but only had an issue with one out if 325.

v7.5 is a deferred code so you might want to upgrade to v7.6 or downgrade to v7.4.121.0.

Sent from Cisco Technical Support iPhone App