topic 620302925 7696 in Wireless

CONFIGURING 2720I WIRELESS ACCESSPOINT

isaaco001 — Mon, 05 Jul 2021 13:41:06 GMT

Dear Community,

I am trying to configure a 2720i Acess point.when i configured 1130AG.I configured the e0 interface and was able to reached the browser gui for the rest of the configuration.Does tehe 2720i have a browser for configuration?In the attached file,you will see that i have configured the g0 interface.The problem is i cant ping that interface at all.I have done a show flash: and boot up process to show important details that i might be missing.

To add,the ap come in lwapp mode and i found the k9w7 in flash so i changed it to standalone through

Boot:flash/standalone image

Thank you all!

how you configured the switch

Sandeep Choudhary — Fri, 10 Mar 2017 12:12:15 GMT

how you configured the switch port where it is connected ?

Also configure the default-gateway on AP.

Regards

Dont forget to rate helpful posts

Hi Sandeep,

isaaco001 — Fri, 10 Mar 2017 13:00:39 GMT

Hi Sandeep,

Thanks for you answer. I have configured the default-gateway now as you can see in the show run in the file attached.192.168.1.1 is the default gateway. What should be configured on the switch?I am still troubleshooting.

Regards,

Isaac

you must allow the VLAN(X) on

Sandeep Choudhary — Fri, 10 Mar 2017 13:10:14 GMT

you must allow the VLAN(X) on switch port.

Hi Sandeep,

isaaco001 — Fri, 10 Mar 2017 14:57:21 GMT

Hi Sandeep,

test

620302925 7696

isaaco001 — Fri, 10 Mar 2017 14:57:22 GMT

test

Sandeep,

isaaco001 — Sat, 11 Mar 2017 06:12:30 GMT

Sandeep,

It finally worked!I just configured the bvi interface with and ip and removed the ip on g0.I have to use a complete new set of patch cords,because i thought i could be layer 1 issue.I can now access the gui.

Attached is the attached configs for sho run(working).

Thanks for amazing support.