topic Wireless setup in Wireless

Wireless setup

amh4y0001 — Mon, 05 Jul 2021 11:55:44 GMT

debug capwap console cli

debug capwap client no-reload

archive download-sw /overwrite tftp://10.0.0.2/ap3g2-k9w7-tar.153-3.JC

more flash:/env_vars | include BOOT

** it didnot helped and following message appears repeatidly:

Translating "CISCO-CAPWAP-CONTROLLER"...domain server (255.255.255.255)

***** can some advise what may be possible reason, or need to correct configuration? (I do not have WLC and want to use AP as standalone).

Hi,

Sandeep Choudhary — Thu, 21 Apr 2016 15:54:10 GMT

Hi,

please go through these posts:

https://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

https://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

Regards

Dont forget to rate helpful posts

Thanks for reply,

amh4y0001 — Thu, 21 Apr 2016 20:06:14 GMT

Thanks for reply,

The first link says the following:

But is it BVI interface instead of Fa 0 ?

 AP588d.0903.e31c (confg)# int fa 0

Hi,

Sandeep Choudhary — Fri, 22 Apr 2016 05:41:58 GMT

Hi,

It must be fa0 or gig0 interface

Please follow the procedure as per my last post.

Regards

Dot forget to rate helpful posts and please mark this question answered, it may help others.

Hi,

amh4y0001 — Fri, 22 Apr 2016 10:24:41 GMT

Hi,

Checked it again and all the time i receive the following message:

Translating "CISCO-CAPWAP-CONTROLLER"...domain server (255.255.255.255)

*** I have following Interfaces:

BVI1                       10.10.10.102    YES TFTP   up                            up
GigabitEthernet0           unassigned      YES manual up                    up
GigabitEthernet1           unassigned      NO unset administratively down

Checked with both BVI and G0, in either interface I can not access TFTP or Ping is not successful.

Hi,

Sandeep Choudhary — Fri, 22 Apr 2016 10:33:18 GMT

Hi,

Still your AP is working with Controller based image.

First convert it to Autonomous mode then start with conifg.

Regards

Don't forget to rate helpful posts

Sandeep you solved it, the

amh4y0001 — Fri, 22 Apr 2016 13:14:58 GMT

Sandeep you solved it, the articles you referred helped me to convert from LWAP to AP., thanks.

Will continue to configure it.