topic Check here: in Wireless

Wireless modus

pcfreak49 — Mon, 05 Jul 2021 11:42:27 GMT

I have a problem when I start up my resume in 800 cisco router and I want to go the wireless module, I'm a different mode, how can I fix it?

Before you configure the

Sandeep Choudhary — Wed, 02 Mar 2016 14:35:59 GMT

Before you configure the wireless settings in the router's setup, you must follow these steps(Check link) to open a session between the router and the access point.

http://www.cisco.com/en/US/docs/routers/access/800/880/software/configuration/guide/880_basic_device_wireless_config.html

Regards

Don't forget to rate helpful posts

I like this command R1 #

pcfreak49 — Thu, 03 Mar 2016 12:20:03 GMT

because if I service-module wlan-ap 0 session to give than I get
Trying 10.10.10.1, 2002 ... Open

Connecting to AP console, enter Ctrl ^ followed by x,
then "disconnect" to return to router prompt

User Access Verification

User: Tim
Password:

ap:

when I start it back I get this message on wireless module

IOS Bootloader - Starting System.
Xmodem file system is available.
Bringing up flash filesystem:
flashfs [0]: 5 files, directories 1
flashfs [0]: 0 orphaned files, directories orphaned 0
flashfs [0]: Total Bytes: 31,481,856
flashfs [0]: Bandwidth used: 38400
flashfs [0] Bytes available: 31,443,456
flashfs [0]: flashfs fsck firing nine seconds.
Reading cookie from flash parameter block ... done.
Base Ethernet MAC address: c8: 4c: 75: 5b: cf: a8
Ethernet Interface initialize.
Ethernet interface initialize OK.
TFTP initialize OK.
button is pressed, wait for button to be released ...
button pressed for 31 seconds
process_config_recovery: Set IP address and config to default 10.0.0.1
Flash: /cpconfig-ap801.cfg: no such file or directory

Configuration restore return 1
The system will go into bootloader for image recovery.
User can download image under bootloader prompt.

ap:

does anyone know how to get

pcfreak49 — Wed, 27 Jul 2016 12:55:32 GMT

does anyone know how to get the image of the wireless router type 800 series, because can not find it?

Check here:

Sandeep Choudhary — Wed, 27 Jul 2016 13:00:03 GMT

Check here:

https://software.cisco.com/download/navigator.html?mdfid=268438003&i=rm

Regards

Dont forget to rate helpful posts

Yes the download link for the

pcfreak49 — Wed, 27 Jul 2016 13:05:50 GMT

Yes the download link for the images but it is intended that I want to delete the images from the 800 series router can not ends in flash

what!!!! Cant understand what

Sandeep Choudhary — Wed, 27 Jul 2016 13:24:19 GMT

what!!!! Cant understand what exactly you want to do!

You want to delete the old image and insert the new one ??? is it you wanna do ?

yes that's right but find it

pcfreak49 — Wed, 27 Jul 2016 13:27:45 GMT

yes that's right but find it not in the flash

I have a problem I can in the

pcfreak49 — Fri, 29 Jul 2016 11:54:49 GMT