topic The only difference is you in Wireless

Wireless Bridge

lenkasurat — Mon, 05 Jul 2021 09:17:18 GMT

Hello Experts!!

I am having CISCO 1242AG nos.2, I want to configure 5GHZ as bridge mode taking traffic multiple vlans. & 2.4GHZ configured multiple SSID to be utilized by the clients over wireless & fast Ethernet to be configured to switch.

I have tried couple of links & configuration too but not working.

Any configuration sample for the same will be appreciated.

THanks //

Basant Lenka

You can refer this post for a

Rasika Nayanajith — Thu, 15 Jan 2015 21:28:18 GMT

You can refer this post for a wireless bridge configuration(use radio 1 instead of radio 0 since you want 5GHz for bridge config)

http://mrncciew.com/2013/11/09/wireless-bridge-with-eap-fast/.

Then try to configure radio 0 as Root AP for wireless users.

Refer this for wired & wireless users behind a WGB if you interest on that

http://mrncciew.com/2014/01/04/wireless-wired-clients-behind-wgb/

HTH

Rasika

**** Pls rate all useful responses ****

Hello Rasika,Thanks for the

lenkasurat — Fri, 16 Jan 2015 23:13:49 GMT

Hello Rasika,

Thanks for the response, the commands were same I have applied however, I have to manually enter into the AP through GUI and mapped the ssid to the VLAN. than the radio get up !!

Thanks for the post to making sure always with you expert guys.

Hi ;Check the following link.

fbarboza — Sat, 17 Jan 2015 05:10:41 GMT

Hi ;

Check the following link.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/69773-vlan-ap-config.html

The only difference is you

fbarboza — Sat, 17 Jan 2015 05:12:15 GMT

The only difference is you only need 1 ssid for the point to point link to come up.