topic Re: Sample config for wireless in Wireless

Sample config for wireless

megatron — Sun, 04 Jul 2021 02:52:20 GMT

Does anyone have a sample config for standalone Cisco AP1252 (Cisco IOS) for AD Authentication for wireless ?

Appreciated your kind reply.

Re: Sample config for wireless

Nicolas Darchis — Fri, 25 Feb 2011 13:12:00 GMT

You can't integrate a 1250 autonomous with AD directly. You have to go through a radius server. Be it Cisco ACS or Microsoft IAS/NPS. From there, it's basic config like in config guide.

Re: Sample config for wireless

megatron — Sat, 26 Feb 2011 08:29:37 GMT

Hi Nicolas,

Thanks for your reply. I found out that I need to install the microsoft IAS and need to know how to configure on the Cisco AP1252 on authenticate via radius.

Pls advise. Tks

Re: Sample config for wireless

Nicolas Darchis — Mon, 28 Feb 2011 07:08:07 GMT

The short version :

in config terminal mode :

-radius-server host auth-port 1812 acct-port 1813 key 0

-aaa authentication dot1x eap_methods group radius

Then you need to configure your ssid for dot1x :

-dot11 ssid

-authentication open eap eap_methods

-authentication network-eap eap_methods

This is only the part needed for radius interaction. This assumes that you already configured your SSID with according WPA settings.

that's about it I think.

If you want info about more commands or so, just check out this link :

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_10b_JA/configuration/guide/scg12410b-chap11-authtypes.html#wp1002608

Re: Sample config for wireless

megatron — Mon, 07 Mar 2011 03:24:20 GMT

Hi Nicolas,

Attached is the sample config.

Pls review if it is correct as not familar with radius authentication

Re: Sample config for wireless

Nicolas Darchis — Mon, 07 Mar 2011 07:43:35 GMT

It's looking good.