topic Document is a bit aged but in Wireless

mesh firmware Cisco AIR-CAP2602I-E-K9.

cbettont — Mon, 05 Jul 2021 10:57:44 GMT

hello,

we have a couple of access point Cisco AIR-CAP2602I-E-K9 that are configured as lighweight access point.

can we convert these access point to mesh firmware ?

We need to configure these access point in Bridge mode as RAP or mesh access points as MAP

is it possible ?

kind regards,

Cristiano

If the AP is already in

PETER MOOREY — Thu, 17 Sep 2015 16:23:38 GMT

If the AP is already in lightweight mode (connected to a WLC) you can change the mode to 'Bridge' which is effectively mesh mode, and then set up the AP as a RAP or MAP.

There isn't a 'Mesh' firmware, the options are either lightweight or autonomous. Mesh is only available using a WLC and therefore lightweight AP software.

Hope this helps,

Pete.

Document is a bit aged but

George Stefanick — Thu, 17 Sep 2015 18:04:35 GMT

Document is a bit aged but lots of information is till the same

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-mesh/111451-indoor-mesh-deploy-guide-00.html

thank you for your feedback.

cbettont — Tue, 22 Sep 2015 14:44:13 GMT

thank you for your feedback. I was able to reconfigure my access-point as mesh

kind regards,

Good to hear that you are

Prakash Parvathala — Wed, 23 Sep 2015 15:00:35 GMT

Good to hear that you are able to solve the issue

Please mark this discussion as correct answered.