topic From the WLC GUI: in Wireless

Flex Connect Group help

Andy White — Mon, 05 Jul 2021 12:20:41 GMT

Hello,

We have a few FLex Connect Groups setup (not by me) and I have just created one for the first time on our 5508 WLC.

I used the GUI and all the settings look the same as the other Flex Connect groups about from what is under the tab called "WLAN VLAN Mapping"

In there is should show the 2 SSIDs. I have attached an image of a good Flex group and the one I'm doing, how do I add the 2 SSIDs? You can see where I have put the cross that the 2 WLANs are missing.

Thanks

Under the WLAN Advanced tab,

Rasika Nayanajith — Thu, 30 Jun 2016 21:29:46 GMT

Under the WLAN Advanced tab, have you enable "FlexConnect Local Switching" ?

HTH

Rasika

Where is this advanced tab?

Andy White — Fri, 01 Jul 2016 11:38:58 GMT

Where is this advanced tab?

From the WLC GUI:

Kyle Nielsen — Fri, 01 Jul 2016 13:24:17 GMT

From the WLC GUI:

on the top navigation select "WLANs", go into each of your WLAN's and click the "Advanced" tab, scroll down about 2/3 the page to the "FlexConnect" section and enable "FlexConnect Local Switching"