topic dual channel connectivity in Wireless

dual channel connectivity

suthomas1 — Sun, 04 Jul 2021 07:52:37 GMT

Hello,

I have two doubts for wireless connectivity,

1. Is it possible that a laptop at one location only uses 2.4Ghz frequency & at some other location uses 5Ghz. From my knowledge, any end node should have 5Ghz capability if it has to use that band.

Is this dependent on the AP providing connectivity or the laptop itself?

2. How is Fast roaming configured and what is the use of it.

Thanks in advance!

Re: dual channel connectivity

Scott Fella — Wed, 18 Sep 2013 16:22:47 GMT

The device chooses what band it will connect to. It doesn't make a difference if its 2.4 or 5. Unless your using band select on one site and not the other, but then again, its the clients decision.

Fast roaming is only required if your doing 802.1x.

Sent from Cisco Technical Support iPhone App

dual channel connectivity

suthomas1 — Wed, 18 Sep 2013 17:28:12 GMT

thanks Scott.

What is band select and who determines it , where is it set upon.

Re: dual channel connectivity

Scott Fella — Wed, 18 Sep 2013 17:31:06 GMT

It depends on the code on the WLC if that's what you have. It under the WLAN advanced tab in the GUI. Autonomous doesn't have that feature. In the end, the client will make the decision anyways.

Sent from Cisco Technical Support iPhone App