Mesh data Rate

csco11030279 — Sun, 04 Jul 2021 05:00:37 GMT

hi all;

I have one RAP one MAP,I set the Bridge data rate to AUTO on both, how can I show the current data rate between them?

what is the MAX range I can space between the RAP and MAP in outdoor and open area ?

Thanks for the supports

Hello, Too late .. I guess,

Cinthya Lineth Villalobos Rojas — Fri, 15 Aug 2014 16:31:59 GMT

Hello,

Too late .. I guess, but for future references you can always use the WLC's CLI commands to view the current data rate:

show ap bhrate <ap-name>

The GUI interface will also display the info:

Wireless > Access Points > All APs Click Detail. The Data Rate and Ethernet Bridging parameters are in the Bridging Information section.

Regards,