topic Change default password on LAP? in Wireless

Change default password on LAP?

kmkrause2 — Sun, 04 Jul 2021 07:25:33 GMT

I have several new 2602e access points configured on two 4408 WLCs. All went surprisiongly well with the installation and configuration. However, I want to change the default user and password, but I'm not sure where to do this from. There doesn't appear to be a configure command in enable mode on the APs and I can't find where the user accounts might be controlled from the controller.

Anyone know the answer?

Thanks!

Change default password on LAP?

Scott Fella — Mon, 15 Jul 2013 19:24:55 GMT

Here is where you would change it. You would also have to enable ssh or telnet on each AP

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

Change default password on LAP?

kmkrause2 — Mon, 15 Jul 2013 19:34:24 GMT

Worked like a charm. Thanks for the prompt reply. I must have passed over that page a dozen times. The light just never went on, I guess

Re: Change default password on LAP?

Scott Fella — Mon, 15 Jul 2013 19:36:31 GMT

Yeah or else its the default Cisco/Cisco.

Sent from Cisco Technical Support iPhone App

Change default password on LAP?

Daniel Ordóñez Flores — Mon, 15 Jul 2013 20:31:11 GMT

Hello Scott.

One questions when you set up an username & password the changes are apply to all AP's ?

Change default password on LAP?

Abhishek Abhishek — Mon, 15 Jul 2013 22:21:59 GMT

Hello Sali,

As per your query i can suggest you the following solution-

To change the default user and password. It can be done under wireless tab then go to global configuration.

Hope this will help you.