topic Re: AIR-CT7510-K9 CLI command in Wireless

AIR-CT7510-K9 CLI command

abinaya.2.r — Mon, 05 Jul 2021 19:33:19 GMT

Hi all,

Can you please tell me the CLI command to check what is the SFP model connected to the WLC. The WLC model is

AIR-CT7510-K9.

Re: AIR-CT7510-K9 CLI command

Rasika Nayanajith — Wed, 23 Sep 2020 18:30:42 GMT

Try below command

show inventory raw | in SFP-

https://mrncciew.com/2014/08/18/wlc-sfp-info/

HTH

Rasika

*** Pls rate all useful responses ***

Re: AIR-CT7510-K9 CLI command

abinaya.2.r — Thu, 24 Sep 2020 02:53:09 GMT

I tried this. I don't get any result

(Cisco Controller) >show inventory raw | in SFP-

Incorrect input! Use 'inventory'

(Cisco Controller) >

Re: AIR-CT7510-K9 CLI command

Rasika Nayanajith — Thu, 24 Sep 2020 03:11:35 GMT

Sorry, I read it as 5760.

If it is AireOS, you can try the below command. Refer that blog post

(Cisco Controller) >debug fastpath cfgtool --dump.sfp

HTH

Rasika

*** Pls rate all useful rate ***

Re: AIR-CT7510-K9 CLI command

abinaya.2.r — Thu, 24 Sep 2020 04:44:23 GMT

(Cisco Controller) >
(Cisco Controller) >debug fastpath cfgtool --dump.sfp

(Cisco Controller) >FP0.
FP0.
Port SFP Vendor       Transceiver Type    OUI PartNumber       Rev SerialNumber     DateCode Auth
   1 Not Present      (0x00)NOT_SUPPORTED                                                     fail
   2 Not Present      (0x00)NOT_SUPPORTED                                                     fail

(Cisco Controller) >
(Cisco Controller) >

I get this above result.. does it mean there is no SFP here? this is a 7510 model and sfp ports.

Re: AIR-CT7510-K9 CLI command

patoberli — Thu, 24 Sep 2020 15:24:14 GMT

Could also mean it's not a Cisco SFP. If you can go on-site and you have an active LAG / Etherchannel, you might simply unplug one and check it.