topic Re: FlexConnect SSID in Wireless

FlexConnect SSID

Mohamed.Ashraf — Mon, 05 Jul 2021 17:34:08 GMT

Hello

I have a lot of branches (DR) connected to HQ through WAN, and there are at least 3 access points in flexconnect mode with own SSID at every branches , and every this working fine.

when i click on wireless button at my laptop i found all SSID breaches appeared to me, can i specific for every branch to appear one SSID for it.

Thank you

Re: FlexConnect SSID

aogston — Mon, 17 Jun 2019 08:59:43 GMT

Re: FlexConnect SSID

aogston — Mon, 17 Jun 2019 09:02:04 GMT

Hi. Create an AP group (maybe 1 per location), add the WLAN's you need in that location, and then the AP's in that location.

Re: FlexConnect SSID

Mohamed.Ashraf — Mon, 17 Jun 2019 10:29:42 GMT

I need access points at location X advertise one SSID for this location not all SSIDs at wireless lan controller.

Re: FlexConnect SSID

craig.beck — Mon, 17 Jun 2019 12:41:51 GMT

Create an AP Group for each location.

Add only the WLAN(s) you need per location to the AP Group for that particular location.

Add APs at each location to relevant AP Group.

Re: FlexConnect SSID

Sathiyanarayanan Ravindran — Tue, 18 Jun 2019 05:53:58 GMT

Hi @Mohamed.Ashraf

As other community members suggested, Create a Separate AP group for each of your branches. Move the Branch APs in to the respective group , Then make SSID and APs as flex-connect, so that only authentication traffic will come to WLC incase of centralized radius environment or PSK based SSID.

Refer : AP Group Cisco WLC