topic Re: Add new access points automatically in FlexConnect mode in Wireless

Add new access points automatically in FlexConnect mode

Heiko Kelling — Mon, 05 Jul 2021 17:17:35 GMT

Hi all,

I have to setup several new Wifi environments with a lot of APs and 3504s. All APs should work in FlexConnect Mode. When I connect a new AP to the network the whole config comes from the controller except FlexConnect mode. So I have to configure all APs on all controllers manually to FlexConnect mode? For a few hundred APs?

Is there any feature or command to save a lot of time and work?

Re: Add new access points automatically in FlexConnect mode

Sandeep Choudhary — Thu, 25 Apr 2019 12:20:57 GMT

You can do it via WLC CLI:

check this post:

https://www.freerkterpstra.nl/2014/09/19/convert-new-access-points-automatically-to-flex-connect-mode/

Regards

Dont forget to rate helpful posts

Re: Add new access points automatically in FlexConnect mode

Sathiyanarayanan Ravindran — Tue, 07 May 2019 14:11:41 GMT

You can use the command config ap mode flexconnect submode none <APName/MACAddress>